Film Casting Knife
Article No. 2325
Film Casting Knife, 5 cm
Adjustable Film Applicator
- Gap Clearance: 0-3800 µm
- Blade Width: 5.1 cm
Features
The film casting knife offers adjustable gap clearances for maximum flexibility.
- Adjustable gap clearances for maximum flexibility
- Available for gap clearances from 0 to 150 mil or 0 to 3800 µm
- Uses highly precise micrometers to set the gap clearance
- Large selection of film widths
Technical Attributes
-
- Blade Width
- 5.1 cm
-
- Measurement Unit
- microns
-
- Gap Clearance Range
- 0 - 3800 µm
-
- Gap Clearance Range mil/µm
- 0 - 3800 µm
-
- Weight
- 0.5 kg
-
- Weight
- 1.2 lb
-
- Dimensions: L x W x H
- 7.6 x 6.4 x 10 cm
-
- Dimensions: L x W x H
- 3 x 2.5 x 4 in
Technical Properties
Technical Specifications
General
Standards
Procedure
- Place substrate to be coated on smooth surface
- Place film applicator with desired gap depth on substrate
- Pour coating in front of gap in pulling direction
- Pull at uniform speed (approx. 25 mm/s)
- Put applicator immediately into diluted cleaning solvent and clean with brush
After each use, clean the instrument immediately with an appropriate solvent. The channels in which the ends of the blade move must be kept free of test material at all times. Avoid getting any solvent or substrate on the micrometer heads. Always dry the instrument off with a towel after cleaning. If the instrument is not used for a long amount of time, it is recommended to apply a thin film of oil to protect the instrument from corrosion.
Downloads
Product Brochure
Operating Manuals
Accessories
Other Variations
Other ALTANA divisions
A member of
