Applicateur de Film avec 2 Hauteurs de Fentes, forme U
Codice art. 5335
U-Shaped Bar 6", 6&10 mils
Applicateur de Film Barre-forme U
- Hauteur de fente: 6 & 10 mils
- Largeur de film: 5.5 in
Special Limited Time Offer of 15% off!
Certificato:
Features
The double bar film applicator has two gap clearances. The U Bar design channels the coating for an accurate film width.
- Large selection of film widths
- Stainless steel construction for long life
Technical Attributes
-
- Gap Clearance
- 6 mil 10 mil
-
- Gap Clearance
- 152 µm 254 µm
-
- Film Width
- 5.5 in
-
- Film Width
- 14 cm
Technical Properties
Procedure
- Place substrate to be coated on smooth surface
- Place film applicator with desired gap depth on substrate
- Pour coating in front of gap in pulling direction
- Pull at uniform speed (approx. 25 mm/s)
- Put applicator immediately into diluted cleaning solvent and clean with brush
- After cleaning, thoroughly dry the applicator and store in a dry place, preferably its case
Downloads
Brochure del prodotto
Accessories
Other Variations
Other ALTANA divisions
A member of
